Agar Stainless Steel Oil Restores Shine and Reduces Fingerprints 5L

In a commercial kitchen, a hotel foyer or a lift lobby, stainless steel shows every finger mark, smear and water spot within hours of a clean. Agar Stainless Steel Oil is a mineral oil blend that goes on after cleaning to bring back an even shine and leave a thin protective film on the metal. The 5Lt pack covers a lot of panels, so one container keeps a run of appliances and fixtures looking maintained for weeks.

How the oil hides finger marks

Wiped on as a very thin film, the oil dries to an invisible layer that sits on the steel rather than soaking in. That film hides finger marks and smears and lets fresh ones wipe away with a soft cloth, which cuts how often a panel needs a full clean. Kept light and buffed to an even finish it holds a clean look between cleans, while laid on too heavily it can collect dust.

Restores an even shine: Wiped on and buffed, the oil lifts the flat, dull look off stainless steel and evens the finish across the whole panel.

Resists fresh finger marks: The dried film holds off finger marks and smears, so busy fridge doors and lift panels stay presentable for longer between cleans.

Marks wipe off with less effort: Fresh smears sit on the oil film instead of the bare steel, so a soft cloth clears them without repeat scrubbing.

5Lt covers large sites economically: One bulk container treats the stainless run across a kitchen, servery or foyer, which suits contract cleaners working several assets in a shift.

Ready to use from the container: No mixing or dilution, so staff apply it the same way every time with a cloth and a few minutes to dry.

Where it can be used:

• Stainless steel panels in buildings, offices and hospitality sites
• Stainless steel around lifts, doorways and escalators
• Appliance exteriors such as refrigerator doors, dishwasher fronts and oven fronts

Not suitable for: Food contact surfaces.

Before you start: Clean the surface and let it dry, so the oil goes onto bare, dry steel.

1. Put a small amount of oil onto a clean, dry cloth or applicator pad.
2. Wipe a thin, even film over the stainless steel, working along the grain.
3. Leave it about five minutes to dry.
4. Buff with a clean, dry cloth to even out the film.
5. If any dry streaks show, add a little more oil to those spots and buff again.
6. Keep the film light, because too much oil can collect dust.

Frequency:
Regular application helps maintain the appearance and protective layer of stainless steel surfaces. Reapply as needed based on usage and environmental conditions.

Download PDS

Download SDS

Safety and storage:

Flammable. This is a Class 3 flammable liquid (UN 1993). Keep it away from heat, sparks, open flames, hot surfaces and other ignition sources, and do not use it near cigarettes, heaters or stoves.
Use it in a well ventilated area. The solvent odour can cause drowsiness or dizziness in a closed space.
Store in a cool place below 30 degrees Celsius, out of direct sunlight, with the container closed and dry.
Keep away from strong oxidising agents.
Keep out of reach of children.
Refer to the current Safety Data Sheet for full handling, first aid and disposal detail.

Environmental and disposal:

This oil is phosphate free.
Dispose of product and containers in line with local council and regulatory requirements.
Do not pour the product down stormwater drains, as it floats on water.
Refer to Section 13 of the current Safety Data Sheet for disposal requirements.