Agar Spray Buff C Spray-Buff Floor Maintenance Liquid 5Lt

Polished floors in busy sites lose their shine fast. Heel marks, scuffs and fine scratches build up between strip-and-seals, and by mid-week a floor that looked gleaming can turn tired and patchy under the lights.

Restore the gloss without stripping the floor

Agar Spray Buff C is a water-based spray-buff liquid that works with a rotary buffer to bring worn polished floors back up. As the pad passes over the sprayed floor, the liquid lifts marks and levels the finish, so scuffs and scratches disappear into an even, glossy surface. Because it is non-residual, nothing is left behind to cloud or dull the coat you already have down.

Run as part of a regular maintenance program, it holds a high-gloss look between full strip-and-seals and protects the sealer underneath. For large venues that means fewer stripping cycles, less downtime and a floor that stays presentable right through the working week.

Key benefits:

Brings worn floors back to a high gloss: restores shine to scuffed, dulled polished finishes as you buff, so the floor looks cared for again.

Lifts scuffs and black heel marks: clears the marks high-traffic areas leave behind, without stripping or re-coating the floor.

Stretches the time between strip-and-seals: maintaining the existing sealer means fewer full re-coats, which cuts labour and product cost on large floors.

Water-based and non-residual: leaves no film to go cloudy or streaky, so the finish underneath stays clear.

Made for machine spray-buffing: runs with a rotary buffer and a soft pad, so cleaning teams can cover large commercial floors quickly.

Where it can be used:

Spray Buff C is for sealed, polished hard floors that carry a floor finish and are maintained with a machine:

• Sealed and polished hard floors that already carry a floor finish
• Commercial and industrial floors kept on a spray-buff maintenance program
• High-traffic areas where the gloss needs topping up between strip-and-seals

How to use Spray Buff C:

1. Sweep or dust-mop the floor and lift off loose dirt and grit.
2. If the floor needs a wash first, damp-mop it and let it dry.
3. Prepare Spray Buff C as directed on the product label, then fill your spray applicator.
4. Lightly spray the floor a section ahead of the machine.
5. Buff with a rotary floor machine and a soft pad in overlapping passes until the gloss comes up evenly.
6. Let the floor dry fully before foot traffic returns or furniture goes back.

Do not mix Spray Buff C with other chemicals unless the label or SDS states it can be done.

Download PDS

Download SDS

Safety and storage:

Spray Buff C causes serious eye damage. It is classified as hazardous, and it is not a dangerous good for transport.

Protection: wear eye or face protection when handling the product, and wash any contacted skin thoroughly afterwards.

If in eyes: rinse cautiously with water for several minutes, remove contact lenses if they are easy to take out, and keep rinsing. Call the Poisons Information Centre on 13 1126 or a doctor.

Storage: keep the container closed and stored away from incompatible substances. Keep out of reach of children.

Environmental and disposal:

Dispose of in accordance with local council and regulatory requirements. Do not pour concentrated product down stormwater drains. If contents cannot be recycled, dispose of them to an approved waste disposal plant. Refer to Section 13 of the current SDS for disposal requirements.