Agar Nu-Glo Silicone Polish and Surface Protector 5Lt

Bring dull vinyl, rubber and trim back to a deep gloss

A surface can come up clean and still look tired. Vinyl greys off, rubber dries out and plastic trim loses its depth. Agar Nu-Glo is the water-based silicone polish and surface protector that takes a cleaned surface the next step, feeding colour and gloss back into it.

The silicone blend soaks into porous materials like vinyl and rubber and leaves a smooth, even film. Because that film bonds to the surface instead of sitting on top, it does not simply wash off on the next water contact, and it holds back the dirt, dust and air-oxidation that dry a surface out and lead to cracking.

The finish is a uniform gloss that makes trims, fittings and fixtures look maintained, with a light lavender scent left behind. It suits vehicle detailing, facility touch-ups and cleaning teams moving across a mix of materials in a single visit.

Where it can be used: 

Use Nu-Glo on finished surfaces where gloss is wanted and grip is not needed.

• Vinyl, rubber, plastic, sealed wood and finished leather
• Car dashboards, tyres, trims and vinyl furnishing surfaces
• Escalator belts and interior woodwork
• Countertops, stainless steel panels and finished smooth leather chairs

Do not use it on floors, steps, seats, steering wheels, pedals or motorcycle seats, or on any surface where a slippery finish would be a hazard.

Deep, even gloss on tired surfaces: the silicone blend enriches dull vinyl and rubber so trims and fittings look maintained again.

Protection that stays put: the film bonds to the surface and resists water contact, so the finish lasts rather than wiping straight off.

Holds off drying and cracking: it shields against the dirt, dust and oxidation that age vinyl and rubber over time.

One product across many materials: it covers vinyl, rubber, plastic, sealed wood, finished leather and stainless panels, so a cleaning team carries less.

Water-based with a light lavender scent: it leaves a clean-smelling finish that sits well on indoor detailing and facility work.

Use NU-GLO straight from the container.

Apply it to a clean, dry surface with a cloth or sponge. Spread the product evenly, let it sit where possible for up to one hour, then buff with a soft clean cloth.

For tyres, trims and dashboards, start with a small amount. Wipe away excess so the finish looks even, not wet or patchy.

For escalator belts, apply NU-GLO to a cloth while the escalator is running. Wipe the moving belt across and along the surface until the finish is uniform.

For stainless steel, brass and chrome, apply a very light amount to a cloth, wipe along the grain and polish back with a clean dry cloth.

Do not over-apply. Excess product takes longer to polish back.

Do not apply NU-GLO to surfaces that may later need painting.

Nu Glo PDS

Nu Glo SDS

Do not apply to walking surfaces, controls, pedals, seats or any area where slipperiness may be unsafe.
Avoid contact with eyes and rinse thoroughly with water if contact occurs.
Use gloves if you have sensitive skin or prolonged contact is expected.
Store sealed in a cool, dry place away from direct sunlight.
Refer to the product SDS before use for full safety guidance.